ESC 100A V2, 6-12S, 4-in-1 Speed ​​Controller

ESC 100A V2, 6-12S, 4-in-1 - professional 4-in-1 ESC for powerful FPV drones, Cinelifter platforms and heavy drones. The controller is built on a modern 32-bit Cortex M4 processor and runs on BLHeli_32 firmware, providing fast signal processing, low latency and stable operation even under extreme loads.

The ESC supports operation with 6-12S (up to 52V) batteries and is designed for 100A constant current and 120A peak load per channel. Thanks to the reinforced 8 oz copper tracks, low-resistance MOSFET 100V 1.5mΩ and massive CNC radiator, the model works effectively in high-current assemblies. The 4-in-1 design greatly simplifies installation and reduces the number of wires in the drone. The ESC supports telemetry, Bidirectional DShot, DShot300/600/1200 and BLHeli_32 passthrough for quick setup via flight controller.

Specifications

• Type: 4-in-1 ESC
• Firmware: BLHeli_32
• Processor: Cortex M4, 32-bit, 120MHz

Power

• Operating voltage: 6-12S LiPo
• Maximum voltage: up to 52V
• Built-in BEC: 16V

Current

• DC current: 100A ×4 channels
• Peak current: 120A ×4 channels

Supported protocols

• DShot300
• DShot600
• DShot1200
• MultiShot
• OneShot
• PPM 1-2us
• Bidirectional DShot

PWM

• PWM Frequency: 8-48kHz
• MOSFET
• MOSFET Type: Low Resistance
• MOSFET Voltage: 100V
• MOSFET Resistance: 1.5mΩ

Telemetry and Features

• Support ESC Telemetry
• Built-in Current Sensor
• Support High Demag Compensation
• Support BLHeli_32 Passthrough
• Support Tuning via DShot commands

Cooling

• CNC aluminum heat sink
• Improved heat dissipation for high loads

Mounting

• Mounting template: 30.5×30.5 mm
• Additional mounting template: 86×66 mm

Dimensions and weight

• Dimensions: 98×72×15 mm
• Weight: 113 g

Interfaces

• JST 8-pin
• Motor outputs M1-M4
• TELE (telemetry)
• CURR (current sensor)
• VBAT / GND
• 16V output for FC

Package

• 1× Lumenier ELITE PRO 100A V2 6-12S BLHeli_32 4-in-1 ESC
• 2× JST split cable (70 mm)
• 2× JST split cable (120 mm)
• 2× 10AWG power wires (160 mm)
• 1× 63V 1800μF capacitor
• 5× M3 rubber dampers
• Mounting kit (nuts, screws, spacers)